Inhoudsopgave
Advertenties
ENGLISH
13. 30Hz LOW CUT FILTER: eliminates unwanted subsonic frequencies under 30Hz. In most cases these
frequencies only consume a lot of energy without any added value to the music.
14. OPERATION MODE switch: Used to set the operation mode of the amplifier. The most common
operation mode is <stereo=. If you need more power, you can operate the amplifier in bridge mode. In
mono mode you only have to connect the left input to drive both outputs. Refer also to n° 3 for more
information.
15. INPUT SENSITIVITY SWITCH: you can choose 3 different input levels: 26 dB / 32 dB / 1,4 V
16. BALANCED XLR OUTPUTS: Can be used to send the signal to the next amplifier. Pin1: signal ground,
Pin2: signal+, Pin3: signal -
17. BALANCED XLR INPUTS: Pin1: signal ground, Pin2: signal+, Pin3: signal –
HOW TO USE
STEREO OPERATION:
• Connect the audio signal to the inputs (15 or 16)
• Set the operation mode switch (13) to <stereo=
• Connect the matching speakers to the L+R Speakon
• Make sure the mains voltage matches 230Vac before connecting the
mains cable to the earthed wall socket.
• Set both input gains (2) to zero
• Make sure there9s a music signal at the input
• Turn the amplifier on (8)
• Adjust the input gains (2) to the desired level
BRIDGE OPERATION:
• Connect the audio signal to the left input (15 or 16)
• Set the operation mode switch (13) to <bridge=
• Connect the matching speaker(s) to the Bridge output (12)
• Make sure the mains voltage matches 230Vac before connecting the
mains cable to the earthed wall socket
• Set both input gains (2) to zero
• Make sure there9s a music signal at the left input
• Turn the amplifier on (8)
• Adjust the left input gain (2) to the desired level, leave the right channel
gain to zero.
MONO OPERATION:
• Connect the audio signal to the input of the left channel (15 or 16)
• Set the operation mode switch (13) to <mono=
• Connect the matching speakers to the L+R Speakon
• Make sure the mains voltage matches 230Vac before connecting the
mains cable to the earthed wall socket
• Set both input gains (2) to zero
• Make sure there9s a music signal at the input
• Turn the amplifier on (8)
• Adjust the left input gain (2) to the desired level, leave the right channel
gain to zero.
®
SYNQ
outputs (11)
®
®
outputs (11)
5/36
OPERATION MANUAL
DIGIT amplifiers
Advertenties
Inhoudsopgave
