Inhoudsopgave
Advertenties
BEFORE FIRST USE
s
Before using your air humidifier for the first time, remove all possibly attached
●
advertisement stickers (except for the type plate).
Should the appliance be stored at very low temperatures, you should let it stand
●
at room temperature for approx. 1 hour before starting to use it.
Only use the appliance when the room temperature lies somewhere between
●
5 °C and 40 °C. The relative humidity should not exceed 80 %. By the way: Rel
ative humidity between 40 % and 60 % is ideal.
GB
The appliance must not be covered, sufficient air circulation around the appli
●
ance is vital for the smooth performance of the humidification function. We
recommend keeping a minimum distance of 50 cm to walls, heaters and other
objects. Make sure that the power adapter has not yet been connected to the
appliance and is not plugged into a power outlet.
1. Carefully remove the motor unit by lifting it up and away.
2. Take the humidification mat out of the appliance base and remove the pack
aging material. Place the humidification mat back in the water basin, the float
gauge is positioned at the centre of the humidification mat and the positioning
ring lies on top of the humidification mat (the studs on the ring are facing down).
The tip of the float gauge is stuck into the central ring. Like that, the float gauge
is fixed into place.
3. Fill the water basin with fresh, cold tap water. The water level is visible through
the viewing panel. Do not exceed the MAX marking.
Caution: Do not mix any additives like essential oils or perfumes into the
●
water! These additives damage the appliance resp. cause discolorations
to the plastic. Appliances that are damaged by adding additives are
excluded from warranty.
82
Note: Humidification will be even more effective if the filled water is not very
●
cold. However, the water temperature should not lie above 30 °C, as this might
damage parts of the appliance.
4. Place the motor unit back on the appliance base. Make sure that the holes in
the nib of the appliance base are aligned to the holes near the connection jack
of the motor unit.
5. Connect the connection plug of the power adapter to the jack on the motor
base.
6. Connect the power plug to the power socket, a signal sounds. Touch the ON/
OFF button to switch the appliance on. A signal sounds, the function lights
indicating the standard setting light up (ON/OFF, LIGHT, II).
S T AR TI N G U P /
s
M AKI NG AD JUSTM ENTS
If you briefly touch the function buttons, the respective setting is made. The
●
corresponding function light glows blue. Each touch of a button is followed by
a sound signal.
;
ON/ OFF BUTTON
Once the power plug is connected to a power outlet, you can start the air humid
●
;
ifier with the
button. A signal sounds, the appliance starts at the medium
humidification level and the LED light in the motor unit lights up, switching
between 7 colours. The function buttons next to
blue (standard setting).
;
Touch the
button again to switch the appliance off. A signal sounds, the
●
display goes out and the appliance switches off.
GB
;
, LIGHT and II light up in
83
Advertenties
Inhoudsopgave
