Download Inhoudsopgave Inhoud Print deze pagina

Electro Depot VALBERG WF 1014 B AID W180C Gebruiksaanwijzingen pagina 11

Inhoudsopgave

Advertenties

B
B
Utilisation de l'appareil
Using the appliance
Install bottom cover
To realize quieter operation, a bottom cover is supplied with the unit (only applies to some
of the washers). After installing the cover at the bottom of the washer, the noise level will be
greatly reduced. Please ask for advice from specialists before installing the cover, nevertheless,
the machine can be used without the bottom cover.
8
Noise-Reduction Bottom Plate Installation Instructions
A:
Stick acoustic wool to the side of bottom cover plate with the letter of «PUMP».
Tilt the washer by 30»-40°, when installing the bottom cover, please face the side with sound
insulation upwards and attach 'PUMP at the corner of the cover to the position of the pump
in the washer.
1
PUMP
B:
1
Right-angle impression
Before installing the noise-reduction bottom plate, align and paste the acoustic absorption
wool with and along the right-angle impression on bottom plate (this procedure is unnecessary
for some of the models without acoustic absorption wool).
2
Remove surface paper on double sided tape at four sides of the bottom plate.
18
18
2
PUMP
Double sided tape
EN
FR
B
B
Utilisation de l'appareil
Using the appliance
3
Incline the machine to an angle of 40° and let the side with right-angle notch face towards
frost of the washing machine, as shown in the figure. Insert the side with oblique-angle notch
between two foot screws at back of the washing machine completely in place. Then, install
the bottom plate and ensure that it contacts with bottom of the washing machine closely.
4
Press the double sided tape on four sides manually to secure the noise-reduction plate to
the machine body firmly.
Connect the water supply inlet hose
9
If the water inlet hose is not already installed, it must be screwed to the appliance.The
blue marked hose is only for cold water. Depending on the model, the hot waterhose marked
with red should also be connected, for models having dual inlets.
Hot (Depending on models} Cold
Screw by hand the inlet hose onto the tap, tightening the nut.
10
19
19
PUMP
EN
FR

Advertenties

Inhoudsopgave
loading

Deze handleiding is ook geschikt voor:

Valberg wf 1014 b aid s180cValberg 972343Valberg 972354

Inhoudsopgave