Cleaning, Care &
Maintenance
•
Switch off and disconnect from the power
supply before cleaning.
•
Clean the interior of the appliance as often as
possible.
•
Do not use abrasive cleaning agents. These
can leave harmful residues.
•
Clean the door seal with warm soapy water.
•
Always wipe dry after cleaning.
•
Do not allow water used in cleaning to run
through the drain hole into the evaporation
pan.
•
Take care when cleaning the rear of the
appliance. Sharp edges can cut.
Condensation and ice will form with frequent
and prolonged opening of the doors.
Operating outside of the recommend
temperature range and placing next to a
heat source will also increase the amount
of ice and internal/external condensation.
If external condensation occurs wipe the
surface down with a cloth.
Excessive ice will result in longer running
times that will increase energy consumption
and increase the deterioration of
components.
Troubleshooting
A qualified technician must carry out repairs if required.
Fault
The appliance is not
working
The appliance turns on,
but the temperature is
too high/low
CR711_ML_A5_v5_20240924.indb 5
CR711_ML_A5_v5_20240924.indb 5
Probable Cause
The unit is not switched on
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
Too much ice on the evaporator
Condenser blocked with dust
Doors are not shut properly
Appliance is located near a
heat source or air flow to the
condenser is being interrupted
If the gasket or seal is damaged or deformed,
energy consumption will increase. To restore
efficiency, replace gasket.
Do not obstruct fans and do not exceed
max load lines, as doing so will impact air
distribution and increase energy usage.
Cleaning the Condenser Filter
•
The condenser is part of the refrigeration
system. The condenser filter requires monthly
cleaning.
•
Always disconnect power supply before
carrying out Routine Maintenance.
•
Failure to clean the condenser will increase
energy consumption, reduce the performance
and life of your Polar unit, and thus may
invalidate your warranty.
•
This model has a removable filter which can be
cleaned with a vacuum cleaner.
Solution
Check the unit is plugged in correctly and
switched on
Replace Plug or lead
Replace the fuse
Check mains power supply
Defrost the appliance
Clean the Condenser
Check doors are shut and seals are not
damaged
Move the refrigerator to a more suitable
location
EN
5
2024/9/24 14:32
2024/9/24 14:32