Inhoudsopgave
Advertenties
ENGLISH
HOW TO CONNECT
STEREO OPERATION:
Most common use, speaker impedance can go down to 2Ω.
Using binding post outputs:
®
Using SpeakON
outputs:
Connect the stereo audio signal to the inputs 1+2 (8/9 + 12/13)
Select "stereo" mode on the display, set the DSP-parameters (see next chapter)
Connect the speakers to the outputs as shown on the drawings.
Set input gain knobs (5) to zero
Make sure there's a music signal at the input
Turn the amplifier on (1)
Adjust the gain knobs (5) to the desired level
BRIDGE OPERATION:
Used to drive 2 channels with bigger power. ~ Attention: speaker impedance below 4Ω is NOT allowed.
Using binding post output:
®
Using SpeakON
output:
Connect the mono audio signal to the input of CH1 (8/9)
Select "bridge" mode on the display, set the DSP-parameters (see next chapter)
Connect the speaker to the output as shown on the drawings.
Set input gain knobs (5) to zero
Make sure there's a music signal at the left input
Turn the amplifier on (1)
Adjust the gain knob of CH1 (5) to the desired level, he gain knob for CH2 is not used.
JB SYSTEMS
®
5/45
USER MANUAL
DSPA-1000 / DSPA-1500
Advertenties
Inhoudsopgave
