Inhoudsopgave
Advertenties
Device-specific additional instructions for nailer
4
Filling the magazine
Ensure that nailer and fasteners are compatible (Chap. 1) with
•
each other.
Check fasteners for proper condition.
•
Pull pusher 1 backwards and engage. Insert staple rod into the
•
magazine from above and push forward. Disengage the
pusher and push it forward.
5
Adjusting drive-in depth
Reduce pneumatic operating pressure as far as possible to
•
minimize blowback, noise and air consumption (see General
operating instructions).
Mechanical adjustment of drive-in depth:
Disconnect the tool from the compressed air supply. Loosen
•
screw 1 on the release bracket and push release shoe 2
downwards for less recessed clamps or upwards for more
recessed clamps. Then tighten screw 1 firmly again and
connect the tool with compressed air.
6
Removing stuck fasteners from the driving channel
Disconnect the tool from the compressed air supply.
•
Remove the staples from the device. Actuate the locking
lever 1 and open the head piece flap 2. Remove jammed
staples. Close the head piece flap 1 again, connect the tool
to the pressure supply and refill the magazine with staples.
7
EU Declaration of conformity
The BeA GmbH, manufacturer or importer, address as on cover sheet, declares under sole responsibility this product's conformity with all
relevant provisions of the EU Machine Directive 2006/42/EG. The following standards are applied:
EN ISO 12100:2010 (Machine safety); ISO 11148-13:2017-11 (Hand-held non-el. machines - Fastener driving tools);
EN 12549:1999+A1:2008 (Noise measuring for driving tools); ISO 8662 (Vibrations at driving tools).
------------------------------------------
Dr. Jörg Dalhöfer, CEO
246/130-944E
-----------------------------------------------------------
Joachim Bauer, Documentation responsible
EN - 7
Advertenties
Inhoudsopgave
