Inhoudsopgave
Advertenties
Device-specific additional instructions for nailer
4
Filling the magazine
Ensure that nailer and fasteners are compatible (Chap. 1) with
each other.
Check fasteners for proper condition.
Pull pusher 1 backwards and engage. Insert staple rod into the
magazine from above and push forward. Disengage the pusher
and push it forward
5
Adjusting drive-in depth
Reduce pneumatic operating pressure as far as possible to
minimize blowback, noise and air consumption (see General
operating instructions).
Mechanical adjustment of drive-in depth:
Disconnect the tool from the compressed air supply. Turn
adjustment knob 1 for deeper countersunk nails clockwise. Turn
anti-clockwise to lower the nails less deeply.
6
Changing the trigger setting
Disconnect
the unit from the compressed air supply, press button
the valve lever from behind and with the other hand set it to single
release (symbol 1 nail) or contact release (symbol with 3 nails).
Reconnect the tool to the pressure source.
7
Removing stuck fasteners from the driving channel
Disconnect the tool from the compressed air supply. Remove the
staples from the device. Actuate the locking lever 1 and open
the head piece flap 2. Remove jammed staples. Close the head
piece flap 1 again, connect the tool to the pressure supply and
refill the magazine with staples.
8
EU Declaration of conformity
The BeA GmbH, manufacturer or importer, address as on cover sheet, declares under sole responsibility this product's conformity with all
relevant provisions of the EU Machine Directive 2006/42/EG. The following standards are applied:
EN ISO 12100:2010 (Machine safety); ISO 11148-13:2017-11 (Hand-held non-el. machines - Fastener driving tools);
EN 12549:1999+A1:2008 (Noise measuring for driving tools); ISO 28927-13:2022-02 (Vibrations at driving tools).
------------------------------------------
Dr. Jörg Dalhöfer, CEO
....3718
.
1 on
-----------------------------------------------------------
Joachim Bauer, Documentation responsible
EN - 13
Advertenties
Inhoudsopgave
