Inhoudsopgave
Advertenties
SELECTABLE OUTPUT BRIGHTNESS
There are two choices of output brightness by different setting on the
surface of the LED light engine:
ON - 100% (standard)
1
- 50%
The switch can be found next to the LED module and can be
seen when you have removed the diffuser.
MOUNTING
1. Disassemble the diffuser with the supplied Allen key and open the LED panel.
2. Pull the power cord through the gasket.
3. Fix the fixture on the surface with screws.
(Pay attention to the direction. This is indicated by the "UP" marking on the base of the fixture.)
4. Connect the power cord on the terminal correctly.
5. Connect the plug of the battery firmly onto the emergency driver.
6. Assemble the LED panel and diffuser.
Min. 18mm
4
Cable connection
MAINS POWER SUPPLY
Remove wire bridge when externally switched
Uninterrupted mains supply (for emergency backup function)
Emergency mode version
TESTING
Test emergency function after installation.
N
L
A
L
14
Min. 45mm
ø6mm
Emergency mode + Sensor version
(switched phase not required)
L, N = Un-switched line
L1
= Switched line
A
= Test emergency operation
www.prolumia.com
PH2
40mm
MAINS POWER SUPPLY
Remove wire bridge when externally switched
Uninterrupted mains supply (for emergency backup function)
Output
Output
Brightness
Brightness
ø4mm
Rubber
Metal
Pay attention:
• With stone, do not drill into the
joint/edge of the stone
• Do not use a pneumatic hammer
drill in soft stone
• Clear the borehole from dust
Advertenties
Inhoudsopgave
