Inhoudsopgave
Advertenties
Operating instructions
D
Mobile rechargeable LED floodlight
with Bluetooth speaker
BLUMO 2000 A
SAFETY INFORMATION
• Carefully read these operating instructions before using the device.
• Do not use the light if it is damaged - danger of death.
In this case, contact an electrician or refer to the specified service address.
• Do not look directly into the light.
• Never open the device.
• The light is protected against spray water. Do not immerse the light in water or any other
liquids. Risk of explosion and fire!
• Keep the working light out of the reach of children. Children are not aware of the risks imposed
by electric current.
• Do not use the working light in potentially explosive atmospheres - risk of death!
• To charge the batteries, only use the provided power supply unit.
SETTING UP/ATTACHMENT OF THE LIGHT
The tilting angle of the light can be adjusted as necessary by means of the folding bracket. To do
so, loosen the winged screws and retighten them after adjustment.
The light can be mounted on a Brennenstuhl tripod (not included in the scope of delivery).
SWITCHING THE LIGHT ON/OFF
Use the ON/OFF switch (A) to switch the light on. The light is now lit with 100 % brightness. Press
the switch twice to set the brightness to 50 % and then 10 %. This way, the lighting duration is
respectively extended. To switch off the device, press the ON/OFF switch (A) again.
BLUETOOTH SPEAKER
To use the speaker via Bluetooth, press the Bluetooth switch (B) with the Bluetooth symbol on the
back of the device: the blue LED over the Bluetooth switch (B) lights up.
Switch on the Bluetooth function on the smartphone: the light is displayed under "HB Blumo 1"
in the selection list. Afterwards, activate HB Blumo 1 on the smartphone: "Bluetooth connected" is
indicated by the light with an acoustic signal.
Any music on the smartphone can now be played via the speaker of the light. The volume is con-
trolled via the smartphone.
To terminate the connection, deactivate "HB Blumo 1" on the smartphone: the light reports "Blue-
tooth disconnected" with an acoustic signal. The connection can also be terminated by switching
off the Bluetooth function via the Bluetooth switch of the light (without acoustic signal).
BATTERY STATUS INDICATOR (C)
Indicates the current battery charge when the light is switched on. If all 4 LEDs are lit, the battery
is fully charged. If the battery is almost empty, the LED light flashes 5 times and the battery status
indicator flashes continuously. Afterwards, the light remains on for 5-10 minutes with reduced
brightness before it is switched off by the deep discharge protection function. This ensures suffi-
cient time to change the battery or complete work.
6
17P053 Mobiler Slim LED Blumo 2000A 180312.indd 6
12.03.2018 12:50:02
Advertenties
Inhoudsopgave
