Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
EN
USING THE KETTLE
1. Remove the kettle from the power base (7) before filling with water.
2. Press the lid opening button (3) to open the lid and fill the kettle up to the desired level (no less than
0.6 l and no more than 1.7 l). Close the lid carefully (2).
3. Put the kettle on the power base (7). Turn on the kettle with the On/Off switch (5). When the
water starts boiling, the kettle will turn off itself. You can always turn it off sooner with the On/
Off switch.
4. Once the water has boiled or the kettle has been turned off with the On/Off switch, wait for 15 to
20 seconds before turning on the kettle again. If the kettle is turned on without any water in it, the
overtemperature safety will turn off the kettle. If this happens, put the kettle away to cool down
for 15 minutes before filling with water.
CLEANING AND MAINTENANCE
Clean the kettle frequently of limescale. Use limescale removing chemicals dedicated to electric ket-
tles (and use the instructions for use of the chemical) or a mixture of water with vinegar or citric acid.
Failure to descale the kettle may result in its failure. Wipe the kettle clean inside and out with a cloth.
Do not clean with a wire brush, scouring pads or strong detergents.
TECHNICAL SPECIFICATION
See the product's nameplate for technical specifications.
Power cord length: 0.66 m
NOTE! MPM agd S.A. reserves the right to introduce technical modifications!
Proper disposal of the product (waste electrical and electronic equipment)
Marking on the product indicates that after the service-life of the product expires, it should not be dis-
posed with other type of municipal waste. Used equipment may have a negative impact on the environ-
ment and health of people due to potentially containing hazardous substances, mixtures and components.
Mixing electric waste with other types of waste or disassembling those in an unprofessional manner may
cause a release of substances that are hazardous to the environment and health. Used equipment should
be handed-over to a point for collection of electric waste. In order to obtain detailed information regarding the
electric waste collection points, the user should contact the municipal point of electric waste collection or used
equipment processing department.
14
Advertenties
Inhoudsopgave
