Inhoudsopgave
Advertenties
10
Press and hold the menu
RX
icon will be displayed on the LCD screen. Your PMR will pick up
signals on the current channel, including background noise.
Press the menu button
4.7
Setting the VOX (voice activated) sensitivity
In VOX mode, the unit will transmit a signal only when it is activated by
your voice or other sounds around you. The unit will transmit further
for 2 seconds even if you stop talking.
The level of VOX sensitivity is shown by a number on the LCD screen.
At the highest level, the units will pickup softer noise (including
background noise); at the lowest level, it will pick up only louder noise.
Press the menu button
"OF" flashes on the LCD screen.
Press the up button
(the maximum level is 3.)
To deactivate the VOX function, press the down button
appears on the LCD screen.
Press the PTT button to confirm your setting.
appear on the LCD screen as along as the VOX feature is activated.
Note:
VOX operation is not recommended if the unit will be used in a noisy
or windy environment.
4.8
Activating the auto channel scan
Channel scan perform searches for active signals in an endless loop for
all 8 channels, 38 CTCSS codes and all 83 DCS codes.
Press the menu button
screen.
Press the up
an active signal is detected, channel scan pauses on the active
channel.
Press the menu button
screen press the up
CTCSS from 1-38.
and down
to stop the channel monitoring.
4 times,
to set the VOX sensitivity into maximum level
5 times,
or down
button to begin scanning channels when
six times, CTCSS flashes on the LCD
or down
buttons at the same time.
VOX
icon will be displayed and
VOX
SCAN
icon will display on LCD
button to begin scanning the
until "OF"
will steady
Advertenties
Inhoudsopgave
