Advertenties
CoolMatic
For safety reasons the refrigerator is equipped with an electronic system to
prevent the polarity being reversed. This protects the refrigerator against
reversed polarity when connecting to a battery and against short circuiting.
To protect the battery, the refrigerator switches off automatically if the voltage
is insufficient (see table below).
Cut-off voltage
Cut-in voltage
Connecting the refrigerator to AC power (accessory)
I
NOTE
The CR140 and all US versions are available in DC/AC version
only. Without using a rectifier, these refrigerators can be operated
using a 110 – 240 V AC current source, in addition to a 12 or 24 V
DC current source.
You can connect the refrigerator to AC power if you use a rectifier
(accessory):
110 – 240 V: MPS35
D
DANGER! Danger of electrocution
Never handle plugs and switches with wet hands or if you are
standing on a wet surface.
If you are operating your refrigerator on board a boat with a
mains connection of 230 V from the land, you must install a
residual current circuit breaker between the 230V mains sup-
ply and the refrigerator.
Seek advice from a trained technician.
I
NOTE
Always connect the refrigerator to the rectifier. Otherwise the pri-
ority circuit for the refrigerator will be disabled.
The priority circuit reduces the load on a connected battery by the
rectifier always switching to mains operation if AC power is con-
nected.
Proceed as follows when you connect the refrigerator to the AC supply:
➤ Fix the rectifier as shown in the location foreseen, behind the refrigerator
(fig. g, page 10).
EN
Installing and connecting the refrigerator
12 V
10.4 V
11.7 V
24 V
22.8 V
24.2 V
45
Advertenties
