Inhoudsopgave
Advertenties
Cleaning, Care & Maintenance
Switch off and disconnect from the power supply before cleaning.
•
•
Clean the interior of the appliance as often as possible.
•
Do not use abrasive cleaning agents. These can leave harmful residues.
•
Always wipe dry after cleaning.
Condensation and ice will form with frequent and prolonged opening of the doors.
Operating outside of the recommend temperature range and placing next to a heat source
will also increase the amount of ice and internal/external condensation. If external
condensation occurs wipe the surface down with a cloth.
Excessive ice will result in longer running times that will increase energy consumption and
increase the deterioration of components.
If the gasket or seal is damaged or deformed, energy consumption will increase. To restore
efficiency, replace gasket.
Replacing the Interior Lamp
Call your POLAR dealer or a qualified electrician, the Lamp Assembly is available to purchase as a spare
part.
Cleaning the Condenser
Periodic cleaning of the Condenser can extend the life of the appliance. POLAR recommend that a POLAR
agent or qualified technician clean the condenser.
Failure to clean the condenser will increase energy consumption, reduce the performance and life of your
Polar unit, and thus may invalidate your warranty.
Troubleshooting
A qualified technician must carry out repairs if required.
Fault
The appliance is not
working
The appliance is not
cooling
The appliance is noisy
Error code EE4
GE960-GE961_ML_A5_v2_20240828.indb 5
GE960-GE961_ML_A5_v2_20240828.indb 5
Probable Cause
The unit is not switched on
Plug or lead are damaged
Fuse in the plug has blown
Mains power supply fault
Too much ice on the condenser
Condenser blocked with dust
Doors are not shut properly
Appliance is located near a heat source,
in the direct sunlight or air flow to the
condenser is being interrupted
Ambient temperature is too high
Appliance is overloaded
Appliance is not level
Appliance is too close to a wall or other
object
•
Restricted Airflow
•
Blocked Condenser
Solution
Check the unit is plugged in correctly and
switched on
Replace plug or lead
Replace the fuse
Check mains power supply
Defrost the appliance
Clean the condenser
Check doors are shut and seals are not
damaged
Move the refrigerator to a more suitable
location
Increase ventilation or move appliance to a
cooler position
Reduce the amount of food stored in the
appliance
Adjust position to make it level
Move to a more suitable location
•
Increase airflow
•
Clean the condenser
EN
5
2024/8/28 11:15
2024/8/28 11:15
Advertenties
Inhoudsopgave
