Inhoudsopgave
Advertenties
Technical Data
type
volt
778
220-240
Before the first use
Read these operating instructions
carefully before using the appliance
for the first time.
• Remove all packing parts and possibly stickers, but
not the type plate nor the serial number.
• Rinse the milk jug, the lid and the frothing spool with
hot water.
• Place the milk frother on a dry, non-slip and level
surface.
EC Label / Safety information
The appliance meets the requirements
of the applicable EC directives.
The appliance is designed
for indoor domestic use only.
ATTENTION! Always unplug
the appliance when not in use
and before cleaning.
• Never leave the appliance unattended while in use.
• The milk jug may overflow if filled high.
• The milk may burn slightly if filled low.
• Please do not move the appliance during operation.
• Make sure you have switched the appliance off befo-
re taking out the milk jug.
• Always use the appliance with the lid in place.
Operation
• Put the milk jug on the base.
• Take the lid off the milk jug.
• Lay the frothing coil in the milk jug. The frothing coil
is held in the middle of the milk jug floor by a magnet.
• Fill the milk jug with refrigerated milk to between the
filling marks MIN (100 ml) and MAX (250 ml).
100 ml of milk makes 250-300 ml of milk foam. 250 ml
of milk makes 500-600 ml of milk foam. In chocolate
mode, you can fill up to CHOCOLATE MAX (450 ml), as
no milk foam is produced in this mode. With 450 ml
milk and max. 80 g chocolate / cocoa, you can make
up to 500 ml drinking chocolate.
Note
If you accidentally operate the milk frother without the
coil, liquid or milk jug, a signal tone will sound three
times and operation will be automatically stopped.
• Put the lid on the milk jug.
• Plug the mains plug into the socket. A signal tone sounds
hz
watt
50/60
500
• If the mains plug is not pulled out of the socket after
• Then press the mode selection button until the LED
• Press the Start/Stop button to start operation. Ope-
• A signal tone sounds, the operation control light flas-
• The appliance then starts to beat the milk.
• When the milk is sufficiently frothed and/or heated,
• Note! The appliance ventilation may continue to run
• You can now take the milk jug off the base.
• Open the lid, scoop the milk froth out separately with
• A magnet ensures the frothing coil stays stuck to the
• Note! The magnetic whisk sticks to most standard
• Caution! Both the milk jug and the milk may be hot.
• The mains plug must be pulled out of the socket to
and the operation control lights flash briefly. Shortly af-
terwards, Cappuccino Mode lights up automatically.
use, the appliance will save the last mode used. Sim-
ply press the mode selection button and the current
mode will be shown.
lights up at the symbol of your chosen program.
ration can be interrupted at any time by pressing this
button again.
hes and the appliance ventilation comes on.
a signal tone sounds twice, the LED lights up with a
steady light and program ends. A short time after, the
appliance goes into standby mode.
after the program has ended.
a spoon, or pour the milk froth out together with the
remaining milk.
milk jug.
household stainless steel spoons. This means it can
be removed directly from the jug with a spoon and
cleaned quickly and easily under running water.
turn off the appliance completely.
Degree of frothing and temperature
Different milk froths can be produced by pressing the
mode selection button (symbol). If the mains plug is
not pulled out of the socket after use, the appliance
will save the last mode used. Otherwise, it will open
in Cappuccino Mode.
Modes
Usage indications
- Hot milk with a small amount of
milk froth
- Suitable for latte or coffee with
Latte
milk
Mode
- The milk is heated to 62-67°C
- The temperature can be raised
further
- Evenly fine-pored milk foam
- The milk is heated to 62-67°C
Cappuccino
- The temperature can be raised
Mode
further
EN
9
Advertenties
Inhoudsopgave
