Inhoudsopgave
Advertenties
CAUTION!
The electric underblanket is only intended for heating beds.
Safety
CAUTION!
• The electric underblanket has been provided with a SAFETY SYSTEM. This sensor technology prevents
overheating of the electric underblanket on the entire surface through automatic deactivation in case
of a breakdown. When the SAFETY SYSTEM has switched off the electric underblanket, the temperature
levels in activated condition are no longer lighted.
• Do note that for reasons of safety the electric underblanket can no longer be used after a breakdown and should
be sent to the indicated service address.
• Never connect the faulty electric underblanket to a different switch of the same type. This would also ensure
a final deactivation through the safety system in the switch.
• Evenly spread the electric underblanket over your mattress. Start at the foot end of the
mattress. By means of the four attachment straps you can attach the blanket to the
mattress, so it cannot shift.
• Place the short straps around the corners of the mattress at the foot end and the long
straps around the corners of the mattress at the head end.
Important: No heating is allowed under the pillow and for that reason the loops on
that side are longer. For a pillow, approx. 50 cm is taken into account. It is the head that
ensures that the body cools down when it is too hot. So if you were to heat your head,
your body would become overheated, which is bad for your health.
• The electric underblanket can be used on both sides, so that you can decide for
yourself on which side (left or right) you want the connection.
• Connect the switch to the connection point in the blanket by connecting the plug.
Approximately, the cord should be at shoulder height.
• Then insert the plug in the socket.
• Then, as usual, lay the fitted sheet over the bed, so that the electric underblanket is
between the mattress and the fitted sheet.
• Each time you make the bed, check that the electric underblanket is flat and properly
spread, before you switch it on.
CAUTION!
Make sure the electric underblanket is spread out fully flat and does not fold or crumple during use. We recommend
switching on the electric underblanket about 15 minutes before you go to sleep and covering it with a duvet to
prevent the heat from escaping.
Slide the position button from position 0 to position 1,2 or 3 to switch on the electric underblanket.
In activated condition, the indication light is illuminated.
Prescribed use
Operation
Use
Switching on
14 • EN
150 cm
80 cm
Advertenties
Inhoudsopgave
