Inhoudsopgave
Advertenties
CP 0003, CP 0004
Connecting a water
separator
The length of the air hose between the compressor
and the water separator must be such that the water
vapor is cooled and condenses in the hose before
reaching the water separator.
If the ambient temperature is below 32 °F (0 °C) the
hose must be short enough to prevent the water
from freezing before reaching the water separator.
Lubrication
The lubricant is important for the machine s function
and has a great impact on the useful service life.
Every day before using and after each eight hours
service, fill the integrated oil reservoir with
recommended lubricant.
Use a synthetic lubricant such as CP Airolene Plus
Tool Oil or mineral oil with the properties
recommended in the table below.
Temperature
Lubricant
range °F (°C)
CP Airolene Plus
-4 to +120
Tool Oil
(-20 to +50)
Air tool oil
-4 to +60
(-20 to +15)
Air tool oil
+60 to +120
(+15 to +50)
Oiler adjustment
Every day before using and after each eight hours
service, fill the integrated oil reservoir with
recommended oil.
1. Remove the oil plug (A) and fill the integrated
oil reservoir with recommended oil.
2. If oiler adjustment is needed, adjust the oil
regulating plug (B), clockwise to reduce flow
and counter clockwise to increase flow.
9800 0557 90 | Original instructions
Fitting and removing the
butt
Whenever fitting or removing the butt the following
instructions must be observed:
♦
Removing
1. Unscrew the lock nut.
2. The butt is fitted to the piston with a taper, so
Viscosity
Fitting
-
100-150 SUS
(ISO VG 22-32)
225-350 SUS
(ISO VG 46-68)
Before fitting the butt, carefully check that the
contact surfaces are clean, both the taper on the
piston rod and inside the butt.
1. Lubricate the threads.
2. Tighten the lock nut. For the correct torque, see
3. Check that the butt is properly pressed up on
Safety and operating instructions
To prevent an accidental start: switch off the air
supply and disconnect the machine from the
power source. Bleed the machine by pressing the
start and stop device.
careful use of a hammer might be needed. Be
careful not to cause damage to the sealing
surface on the piston rod.
section "Tightening torques".
the piston rod taper.
13
Advertenties
Hoofdstukken
Inhoudsopgave
