Download Inhoudsopgave Inhoud Print deze pagina

Beper BT.710Y Handleiding pagina 8

Inhoudsopgave

Advertenties

Beschikbare talen
  • NL

Beschikbare talen

  • DUTCH, pagina 34
Crepe Maker Use instructions
Note: for the first (1-2) uses, it may be that the product emits a little smoke and a slight burning smell.
This is normal and does not preclude the good use of the product. However, it is advisable not to use the
first crepes but to do some for the sole purpose of starting the appliance.
After about 3 minutes the product is ready to be used.
Grip the product by the handle and turn it upside down so that the non-stick plate comes into contact with the
mixture previously prepared and placed in the bowl.
Pay attention not to immerse all the product.
Return the product to the initial position, and if necessary wait a few seconds for the crepe to reach a good
browning.
With the help of a wooden or plastic spatula (not metal because it could damage the surface) lift the edges of the
crepe, turn it and wait the cooking ends before removing it.
After use, switch off the product with the on / off button, unplug the power cord from the power outlet, allow the
product to cool and proceed with cleaning.
Cleaning and maintanance
Important
Disconnect the power cord from the power outlet and leave the product cool down before cleaning.
Never immerse the product in water or other liquid.
Never store the product while it is still hot and / or dirty.
Never wrap the cable around the product too strictly to avoid damaging it.
Clean the product after each use.
The product can be cleaned using a soft, slightly damp cloth.
Clean the bowl with water and neutral soap, rinse well and dry.
Do not use too aggressive soaps, abrasive sponges or other products that could damage the product.
Wait until the product is dry before storing it or using it again.
Technical data
Power:800W
Power supply: 230 V~ 50/60Hz
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
The European directive 2011/65/EU on Waste Electrical and Electronic Equipment (WEEE), requires
that old household electrical appliances must not be disposed of in the normal unsorted municipal
waste stream. Old appliances must be collected separately in order to optimize the recovery and
recycling of the materials they contain, and reduce the impact on human health and the environment.
The crossed out "wheeled bin" symbol on the product reminds you of your obligation, that when you
dispose of the appliance, it must be separately collected.
8

Advertenties

Inhoudsopgave
loading

Inhoudsopgave