Advertenties
Beschikbare talen
Beschikbare talen
UNPACKING INSTRUCTION
CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must be
returned, it is important that the product is returned in the original factory box and packaging.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
The label on the back/under side of the product indicates the mains voltage to which it must be connected. Check that the mains
voltage corresponds to this. Any other voltage than the one indicated may cause irreparable damage to the unit. The unit must
also be connected directly to the mains voltage and no dimmer or adjustable power supply may be used.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
CONTROLS AND CONNECTIONS
1. DSP SETTINGS USB PORT: Our sound engineers have set up the
speakers to do full justice in most applications. In specific cases, it may be
necessary to adjust the DSP settings. Software for this is available on
request. Note: Any changes made to the settings are at own risk.
2. BT STREAMING AUDIO BUTTON: See chapter "CONNECTING WITH BT
FOR AUDIO STREAMING" for detailed instructions on how to set up a BT
connection.
3. COMBO JACK INPUT: Combo jack input, suitable for both XLR and 6.3mm
jack.
4. MIX OUTPUT: XLR mix output for channel A and B.
5. DSP CONTROL: Knob to control the digital sound processor.
Mode: Music / Live / Speech / DJ
Location: Normal / Monitor
EQ: High / Mid / Low
Sub: Off / 80Hz / 100Hz / 120Hz / 150Hz
Delay: Off / 0.1~16ms per 0.1ms
LCD Dim: On / Off
Brightness Level
Contrast Level
6. OUTPUT LEVEL CONTROLS: Adjust the volume of both A and B
channels.
7. MIC – LINE SWITCH: Switch between microphone and line channel.
8. POWER CONNECTOR B: Socket for plugging in the supplied power cord.
9. FUSE HOLDER: For instructions on how to replace the fuse, please see
chapter "REPLACING THE FUSE".
10. POWER SWITCH: Switch to turn the device ON or OFF.
REPLACING THE FUSE
If the fuse is defective, replace the fuse with a fuse of the same type and value.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel
with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
CONNECTING WITH BT FOR AUDIO STREAMING
If password is required, you can enter "0000".
Attention: The streaming distance is approx. 10 meter without any barrier.
1.
Activate the BT audio streaming function on your mobile device (smartphone, tablet etc.)
from which you want to stream the music. Before attempting, please check the operating
instructions corresponding with that device.
Press the "BT" button to activate the streaming audio function.
2.
Select "PDY SPEAKER" on your mobile device to initiate the connection.
3.
3
Advertenties
