Download Inhoudsopgave Inhoud Print deze pagina

Kuppersbusch FWK2800.0S Handleiding pagina 75

Inhoudsopgave

Advertenties

Beschikbare talen
  • NL

Beschikbare talen

  • DUTCH, pagina 81
around 30 minutes to increase the wine cooler's temperature from 5℃ to 12℃. Under the same
circumstance, it will take around one hour to decrease the wine cooler's temperature from 12℃
to 5℃. The less the temperature span is, the less time it will take. The setting temperature of
upper zone should be lower than the setting temperature of lower zone
6. EQUIPMENT
The climate control system
According to advice from specialists, the ideal temperature for storing wine is around 12°C, within a
bracket of 10 to 14°C. Do not confuse this with service temperature, which varies between 5 and 18°C,
depending on the specific nature of the wine.
It is especially important to avoid sudden changes in temperature. Designed by specialists for
oenophiles, this appliance, unlike a simple refrigerator, takes into account the sensitivity of grand cru
wines to sudden variations in temperature by ensuring the close control of a constant average
temperature.
The anti-vibration system
The refrigeration compressor is equipped with special dampers (silent-blocks) and the inner space is
insulated from the body by a thick layer of polyurethane foam. These characteristics prevent the
transmission of vibration to your wines.
The anti-UV system
Light accelerates the ageing of wine. In our solid door cellars, your wines are naturally protected, on
condition, of course, that the door is not opened too often. This glass-door model has been specially
treated and filters out harmful ultraviolet rays, thus ensuring your wines are perfectly shielded.
Defrosting
Your appliance is equipped with an automatic defrost cycle. When a cooling cycle finishes, the
appliance's refrigerated surfaces are defrosted automatically. The defrost water is channeled into a
condensates evaporation tray which is located in the back of the appliance near the compressor. The
heat produced by the compressor then evaporates the condensates collected in the tray.
Shelves
To prevent damage to the door seal, ensure that the door is fully open before pulling out the shelves
to add or remove bottles.
For easier access to the contents of the shelves, slide the shelf out approximately one third of the
way. The shelves are, however, fitted with a stop to prevent the bottles falling out.
To remove or reposition the shelves, move the shelf to the position where the notch of wooden shelf
is exactly under the plastic post and lift the wooden shelf. Please ensure these are replaced when
the shelf is put back.
73

Advertenties

Inhoudsopgave
loading

Gerelateerde Producten voor Kuppersbusch FWK2800.0S

Inhoudsopgave