Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
3.3
Possible misuse
▶ Do not use the power tool to cut bricks, concrete, cellular concrete, natural stone or tiles.
▶ Do not use the product to cut pipes containing liquids.
▶ Do not saw into unknown materials.
3.4
Lithiumion battery status display
The Li-ion battery state of charge and malfunctions of the power tool are indicated by the display on the Liion
battery. The Liion battery state of charge is displayed after pressing one of the two battery release buttons.
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED blinks.
1 LED blinks, the power tool is not ready for use.
4 LEDs blink, the power tool is not ready for use.
Battery state of charge cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch.
If the battery display LEDs blink, please observe the instructions given in the Troubleshooting section.
3.5
Items supplied
Reciprocating saw, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
4
Technical data
Product generation
Rated voltage
Weight in accordance with EPTA procedure 01
Stroke rate (Stage 1)
Stroke rate (Stage 2)
Stroke length
Blade holder
Ambient temperature for operation
Storage temperature
4.1
Noise information and vibration values
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure.
The data given represent the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools, or is poorly maintained, the data can vary. This can
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the power tool is switched
off, or when it is running but not actually being used for a job. This can significantly reduce exposure over
the total working period.
18
English
Meaning
State of charge: 75 % to 100 %
State of charge: 50 % to 75 %
State of charge: 25 % to 50 %
State of charge: 10 % to 25 %
State of charge: < 10 %
The battery has overheated or is completely dis-
charged.
The power tool is overloaded or has overheated.
SR 30-A36
01
36 V
5.2 kg
2,000 /min
2,800 /min
32 mm
0.5 in
−17 ℃ ... 60 ℃
−20 ℃ ... 70 ℃
2186517
*2186517*
Advertenties
Inhoudsopgave
