Advertenties
Beschikbare talen
Beschikbare talen
OPERATION
Adding salt
EN 12
This machine is equipped with a water softener. To use the water
softener, fill the dishwasher with salt.
1. Remove the bottom basket and then unscrew the cap from the
reservoir.
2. Before filling the reservoir for the first time, pour in one litre of water.
3. Insert the funnel into the reservoir opening. Pour in approximately
1 kg of salt. It is normal for a little water to flow out of the opening
when doing this. Note! Clear up any spilled salt and always run a
full cycle immediately afterwards to prevent damage to the bottom.
4. Screw the cap back on firmly.
Note! Always fill the salt reservoir and adjust the water hardness setting
before using the dishwasher. Refill the salt reservoir when the water
softener indicator lights up. It is possible that the light will remain lit for
a short while after the salt reservoir is filled. It will go out automatically
when enough salt has been dissolved in the water.
Setting the salt consumption
• Open the door ,Switch on the appliance;
• Press the Program button for more than 5 seconds to start the
water softener set model within 60 seconds after the appliance
was switched on( The Salt and Rinse aid warninglights will be on
periodically when it get in the set model );
• Press the Program button to select the proper set according to your
local environment, the sets will change in the following sequence:
H1->H2->H3->H4->H5->H6;
• Press the Power button to end the set up model.
Adjust the salt consumption according to the table below:
WATER HARDNESS
degrees Clark
ºdH
0 - 5
0 - 6
7 - 14
6 - 11
12 - 17
15 - 21
22 - 28
18 - 22
23 - 34
29 - 42
43 - 69
35 - 55
Your local water authority can inform you how hard your mains water is.
mmol/l
setting
0 - 0,94
H1
1,0 - 2,0
H2
2,1 - 3,0
H3
3,1 - 4,0
H4
4,1 - 6,0
H5
6,1 - 9,8
H6
salt consumption
(grams/cycle)
0
9
12
20
30
60
Advertenties
