Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Cleaning the clipping head:
The clipping head should be thoroughly cleaned once a day with regular use.
Switch the device off. Disconnect the device from the power supply. Remove the comb attachment and press in the centre of the shearing blades
to remove them (fig. 5). Remove the hair with the cleaning brush.
Place the clipping head back onto the clippers as shown in fig. 6. Make sure that the maximum cutting height (1.9 mm) is set and that the
locking mechanism is positioned properly and press the cutter head onto the device until it engages.
fig. 5
fig. 6
Oiling the clipping head:
The clipping head must be oiled to ensure the good cutting results of the clipping head for as long as possible (during operation every 15 min.
and when stored, preferably on a daily basis). Remove the comb attachment. Use the brush to clean the cutting edge, removing the hair between
the blades. Oil the locations where the upper and lower part of the clipping head touch. The device must be oiled immediately when the shearing
performance diminishes noticeably or the temperature of the clipping head seems too high. The clipping head should be oiled once per day when
the clippers are not in use.
Replacing the clipping head:
The clipping head is a wear part. Despite good care, the cutting performance will diminish. At this point, the clipping head should be replaced.
The clipping head can be ordered individually as a spare part (ref. no. 18465). When replacing the clipping head, you can remove the residue
hair within the clippers using the brush. Press in the centre of the shearing blades to remove them (fig. 5). Place the new clipping head back onto
the clippers as shown in fig. 6. Make sure that the maximum cutting height (1.9 mm) is set and that the locking mechanism is positioned pro-
perly and press the cutter head onto the device until it engages.
Cleaning the device:
Wipe off your device occasionally using a moist cloth, then rub it dry.
5. Troubleshooting
What to do, when...
... the device cannot be switched on?
• is the battery empty? Connect the power pack and charge the clippers
• is the clipping head dry? The clipping head must be oiled
... the clipping head does not operate smoothly?
• the clipping head must be oiled
• the top and bottom blades can become stuck when not in use for longer periods of time
... the charging display does not light up when charging?
• make sure that the power pack is connected properly
... the device switches off by itself?
• the battery is empty. Charge the clippers
... the battery can no longer be charged?
• the battery or the power pack is defective. The power pack can be re-ordered. If the battery is defective, then the device must be
disposed of properly.
15
Advertenties
Inhoudsopgave
