EN
Scraping
•
After each use, scrape the appliance with a scraper/grill stone/copper brush or flexible spatula to
remove excess fat and food. A waste tray is provided for the scrapings if necessary.
•
If there is an accumulation of burned fat or food, the cooking surface should be thoroughly scoured
and re-seasoned.
Note: It is vital that the cooking surface is re-seasoned after scouring.
Warning: Do not use steel wool as it may leave shards that could Contaminate
food.
Waste tray
•
This appliance features a waste tray to collect any liquid or fats that run off during cooking
•
At least once a day, remove and empty the waste tray before washing with warm, soapy water.
•
Do not allow the tray to overfill, or excess grease will run out of the overflow hole at the front of the
tray.
Warning: Do not remove the tray during or immediately after use as the
contents will be hot.
Troubleshooting
A qualified technician must carry out repairs if required.
Fault
Appliance not
The unit is not switched on
working
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
Appliance does
Faulty thermostat
not reach set
Faulty element
temperature
Appliance heats up
Indicator light has expired
but indicator light
does not come on
Power indicator
Faulty element
light comes on but
Faulty thermostat
appliance does not
heat up
Thermostat set incorrectly
Appliance slow to
Cooking surface not cleaned
heat up
Faulty element
No power
Thermal cut-out switch is
activated
6
FC380-FC386_ML_A5_v3 20220613.indb 6
FC380-FC386_ML_A5_v3 20220613.indb 6
Probable Cause
Check the unit is plugged in correctly and
switched on
Replace plug or lead
Replace the plug fuse
Check mains power supply
Replace the thermostat
Replace the element
Replace the indicator light
Replace the element
Replace the thermostat
Check thermostat
Clean cooking surface as instructed
Replace the element
Press re-set switch on rear of unit
Solution
2022/6/13 下午5:38
2022/6/13 下午5:38