Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
EN //
USER GUIDE
P RO D U C T F U N C T I O N
3. START/STOP
In operation preparation mode, press the "start/stop" key to start the machine (the heating indicator light
and water circulation light will begin to flicker). Press the "start/stop" key for the second time, the machine
will begin the countdown. Press the "start/stop" key for the third time and the machine will stop working
(the heating indicator light and water circulation light will turn off). If the temperature reaches the setting
temperature, the machine will automatically start the countdown.
4. TEMP / TIME
Temperature, time adjustment switch button
•
Click on TEMP / TIME to toggle the temperature or time setting. When the temperature digital reading (B)
is flashing, set the desired target temperature with + and -. When the time digital reading (C) is flashing, the
desired target time can be set with + and -.
* If no time or temperature has been set after the digital reading flashes 10 times, the iVide Plus Jnr Thermal
Circulator will exit the TEMP / TIME option. If you need to reset click TEMP / TIME again to enter the
required details.
* To display the set time and temperature, press the TEMP / TIME button for 3 seconds.
5. + -
Adjustment button
•
To adjust the temperature or time, click on TEMP / TIME, select your required option and use the + and -
buttons to adjust.
6. Temperature Digital Reading (A)
•
Display real time working temperature.
7. Temperature Digital Reading (B)
•
Display the set operating temperature.
8. Time Digital Reading (C)
•
In operation preparation mode, the set target time is displayed.
•
In working mode, the remaining working time is displayed.
Factory Reset
In the preparation mode, press and hold the START/STOP and + buttons, the large digital tube will display the
set temperature of 60ºC, and the small digital tube will display the set time of 24:00, and then let go, the large
and small digital tubes will flash 10 times at the same time and exit the setting, and the factory reset will be
successful.
Temperature calibration
1. In the work preparation mode, press and hold Set and ºC/ºF buttons for about 1 second, the machine enters
the thermostat calibration mode, and the digital tube displays P±calibration value
2. At this time, adjust the calibration value up or down by pressing the + or - key, the maximum adjustment
range is ±3ºC
3. After adjusting the calibration value, you can wait for 13-15 seconds, and if there is no operation during the
period, the machine will automatically exit the calibration mode. Or manually press the power button to exit
the calibration mode.
4. The machine remembers the calibration value of the most recent adjustment.
6
Advertenties
Inhoudsopgave
Probleemoplossen
