Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
TO TURN OF THE ALARM
During "STANDBY OFF" mode,
• Press the ALARM 1/VOLUME- button to turn Alarm 1 off.
• The Light Indicator of Alarm 1 will disappear.
Note: This is the same as setting up Alarm 2.
TO PLAY THE RADIO
1. Press the ON/OFF switch to the "STANDBY ON"
2. Use the REVERSE/HOUR button and the FORWARD/MINUTE button to adjust the radio
frequency as instructed above.
3. Use the ALARM 1/VOLUME - button and the ALARM 2/VOLUME + button to adjust the
volume as instructed above.
TO WAKE UP TO RADIO/BUZZER
1. For alarm 1, set the alarm as previously instructed.
2. After setting the time, press again the ALARM 1/VOLUME- button and the radio frequency is
shown.
- Use the REVERSE/HOUR button and the FORWARD/MINUTE button to choose to wake
up from Radio (displayed as frequency) or Buzzer (displayed as BU)
3. Press the ALARM 1/VOLUME- button again to exit the ALARM SETTING MODE.
Note: This is the same as Alarm 2.
SLEEP CONTROL
1. Press the ON/OFF switch to the "STANDBY ON"
2. Press the TIME SET/SLEEP SET button to choose the Device-Sleep time from 90 to 10
minutes (10 minutes interval).
3. Device will turn off after the displayed minutes from 90 to 10 minutes.
4. To turn this off press the TIME SET/SLEEP SET button until the display shows "OFF".
TO SNOOZE
When you are awakened by buzzer but wish to sleep a few to sleep a few minutes more, simply
touch the "snooze" button and it will shut off the buzzer for 9 minutes before the music or buzzer
sounds again. This can be repeated.
TO LISTEN TO PRESET STATIONS
1. Set your desired frequency to be ready as a PRESET STATION.
2. Press the MEMORY button to enter PRESET SETUP MODE.
3. P01 will blink and press again the MEMORY button to set the current frequency as P01.
4. Repeat step 2 and step 3 until PRESET stations from P01 to P10 is setup.
5. Press the PRESET button listen to preset station P01.
6. Press again the PRESET button to move on to preset station P02, and do the same to reach
other preset stations.
7. To change the preset stations repeat the steps above
8. To restore default setup eliminate the power source of the device.
BATTERY BACK-UP
Your clock has a battery back up feature in case of power failure. 2 AAA batteries (not included)
is required. You must put in the batteries to ensure the battery back up feature is ready in case
of power failure. If power fails, the back up battery will automatically continue operation of the
clock and maintain actual time. However, the display will not be lighted. During actual power
failure the alarm function will not be operational. When electrical power is restored, the display
will light up again and alarm time set previously is restored. The battery will maintain timekeeping
for approximately 8 hours during power failure or interruption.
Note: Remove the battery if the clock is to be unplugged for a long time avoid unnecessary
battery drain.
ENG-5
Advertenties
Inhoudsopgave
