Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
The following instructions are intended for a qualified fit-
ter to guide him/her along the installation, adjustment and
technical maintenance procedures as correctly as possi-
ble and in full compliance with the applicable norms in
force.
Important : unplug the hob before all operations.
Installation
•
This hob can be built into a worktop simply by cut-
ting out the corresponding slot.
•
The worktop must be made with a material designed
to withstand a temperature of approximately 100°C.
•
The hob should be positioned at least 40 mm away
from the back wall or any other vertical surface in or-
der to allow for correct ventilation and to prevent the
surfaces around the appliance from overheating.
•
If you wish to install the hob on top of an oven, the
latter must be fitted with a cooling fan.
•
Try to avoid installing the hob on top of a dishwasher;
if this is unavoidable, place a watertight separating el-
ement between the two appliances.
Installation and fastening
Fastening
Very important: It is vital that you ensure the glass ce-
ramic hob is built into a perfectly flat supporting surface.
Deformations due to improper fastening could alter the
characteristics of the hob and compromise its perform-
ance.
The fastening springs are fastened by screws (see dia-
gram).
It is vital that these screws be kept accessible at all
times.
Insert the hob into the cut-out slot, applying pressure all
along the perimeter of the hob frame so that the latter
adheres fully to the worktop.
Distance to
keep between the
cut-out slot and
the cabinet
22
REAR SPRING ASSEMBLY
HOB FROM BELOW
FRONT OF HOB
KITCHEN
WORKTOP
Advertenties
Inhoudsopgave
