Inhoudsopgave
Advertenties
Proximity Tag Operation
Present the
Proximity Tag to
the keypad (after
waking the keypad)
as shown in the
following
illustrations:
Sleep Mode
For extending the battery life of the keypad, the keypad is designed with a Sleep mode
function. By default, 10 seconds after the last key has been pressed, the keypad will
turn off its display.
Replacing Batteries
1.
Remove the fastening screw that secures the mounting bracket to the keypad
(see Figure 1).
2.
Slide the keypad and remove it from the mounting bracket.
3.
Remove the battery compartment cover.
4.
Disconnect the battery cable from the battery connector.
5.
Replace the batteries while paying attention to the polarity of the batteries (see
Figure 9).
6.
Reconnect the battery cable to the battery connector.
7.
Close the battery compartment cover, place the keypad back on the wall and
secure the screw to its place.
CAUTION: Risk of explosion if battery is replaced by an incorrect type. Dispose of
used batteries according to local regulations.
05/2024
Figure 8
Figure 9
Page 10
5IN3045 D
Advertenties
Inhoudsopgave
