Advertenties
Beschikbare talen
Beschikbare talen
Programming signals and assignment to the event icons
A transmitter (e.g. doorbell pushbutton) can be assigned to each event icon.
This assignment can be adapted by programming. Up to 8 transmitters can be
assigned to each icon.
Please keep in mind that a transmitter can only be assigned if it is not yet stored
in the memory of the signolux-Gateway. If required, you might first have to delete
the transmitter from the memory (see next paragraph).
a) Keep the function button »
light up in sequence. Let go of the function button as soon as the desired
icon is lit. (e. g. doorbell icon).
b) Trigger the signal of the transmitter you want to assign to the lit up icon. (e.g.
operate the doorbell button).
c) Wait for about 20 seconds and test the function.
Deleting transmitters from memory
To delete a transmitter from memory, do the following:
a) Keep the function button »
light up in sequence. Let go of the function button as soon as the desired
icon is lit.
b) Now press the function button »
time. All event icons will briefly light up.
Please note that this will delete all transmitters assigned to the according
icon.
Internet-Status-LED
LED is on: Internet connection is established and active.
LED is blinking: No internet connection. Please check the network cable con-
nection or the settings of your internet router.
Transmission range
The radio signals of the Signolux transmitters within the house are designed to
have a range of 200 meters under ideal conditions.
English 22
•
« pressed for some time. The event icons begin to
•
« pressed for some time. The icons begin to
•
« and the delete button »
« at the same
°
Advertenties
