Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
EN
Removing the lodged food
If a piece of food gets lodged onto the
attachments, please follow the instructions below:
1. Release the power button to stop, then
disconnect from power supply and let it come
to a complete stop.
2. Press the Eject button to release the
attachments, then use a rubber/wooden
spatula to remove the food lodged. Caution:
The blade is sharp - Never attempt to use
fingers to remove any lodged object.
Recipe
Recipe below is provided for references only.
Blending carrot into pulp:
Attachment: shaft
Instructions: Put 280g carrot (pre-cut into pieces)
and 420g water into the measuring jug; Start with
low speed then use Turbo function for 15 seconds.
Repeat the cycle until carrot is blended into fine
pulp.
Chopping meat:
Attachment: Chopper assembly
Instructions: Remove bone from meat, cut meat
into pieces and put in the bowl. Max quantity of
meat cannot exceed 200g in every processing.
Start with low speed then use Turbo function for
15 seconds. Repeat the cycle until meat is minced.
Troubleshooting
A qualified technician must carry out repairs if required.
Fault
The appliance is
The unit is not switched on
not working
Plug or lead is damaged
Fuse in the plug has blown
Mains Power supply fault
Appliance slows
Too many contents in the
down
container
Wrong mixing attachment used
Loud noise
Mixing attachments not correctly
fitted
Mixing attachments deforms
6
FB973_ML_A5_v2_20230925.indb 6
Beating egg white into foaming shape:
Attachment: Balloon whisk
Instructions: Pour egg white in the jug. Normally
2 eggs' white is enough. Run the appliance for
2 minutes and repeat if necessary.
Cleaning,
Care & Maintenance
•
•
•
•
•
•
Quick cleaning
Between processing tasks, hold the blender in a
container half filled with water and let it run for a
few seconds (Never exceeding 15 seconds).
Probable Cause
Before cleaning, always disconnect motor
unit from power supply, let it cool down
and come to a full stop.
Clean the motor unit surface with a damp
cloth. Never immerse the motor part in water
or rinse it under running water.
Use warm soapy water to clean blending
attachments, jug and bowl. Do not use
abrasive cleaning chemicals as these can leave
harmful residues.
Dry all parts thoroughly after cleaning.
Always dry the blades well after
cleaning to avoid spotting.
Measuring jug and chopper bowl can
not be used to store food for long time.
Solution
Check the unit is plugged in correctly and
switched on
Replace plug or lead
Replace the plug fuse
Check Mains Power supply
Turn off the unit and remove some of the
contents. Adjust the food formula if needed
Select suitable attachment
Remove and refit attachments
Contact a qualified technician
2023/9/25 17:17:18
Advertenties
Inhoudsopgave
