Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
PrODuCT
SETuP
ProDuCt instAllAtion
PC
AP
setuP usinG tHe Built-in WeB interFACe
To configure your DAP-1665, open a browser on the connected computer. Go to http://dlinkap.local./
to run D-Link setup wizard and follow the onscreen instructions.
If you have more than one access point, enter http://dlinkapxxxx.local. (where xxxx represents the
last four digits of the access point's MAC address, which is located on the label on the bottom of the
device).
4
POSITION THE ACCESS POINT (AP)
Place the access point in an open area of your intended work area for
better wireless coverage. If you are using it as a repeater, you should
ensure that the access point is within wireless range of the network
which you wish to repeat.
TurN ON THE POWEr
Plug the supplied power adapter into the back of the DAP-1665 and
connect it to a power outlet. Press the power switch at the back of
the access point to turn on the power. Wait about 30 seconds for the
device to complete startup processes.
CONNECT THE DAP-1665
Using the included Ethernet cable, plug one end into the LAN port on
the back of the DAP-1665, and plug the other end into the Ethernet
port on your computer. Alternatively, you can connect to the DAP-1665
using Wi-Fi. Go to your computer's WiFi settings. Select the network
name (SSID) that is printed on the included Wi-Fi Configuration Note
(e.g. dlink-A8FA), then enter the Wi-Fi password also printed on the
Wi-Fi Configuration Note (e.g. akbdj19368).
LOGIN URL :
http://dlinkap.local./
ADMIN PASSWORD:
(blank by default)
DAP-1665
Advertenties
Inhoudsopgave
