Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
6.2
Menu
mode
auto
sound
speed
sensitivity
silent scene
InFr
addr
slave
display
6.3
Stand-Alone Mode
The device starts running in stand-alone mode after connection to the mains. This mode
allows you to use the device without controller.
Connect the device to the mains to switch it on. Press MENU to enter the menu. Select
the auto mode and confirm.
6.4
Master/Slave Mode
The master/slave mode allows for connecting several devices to a single master device
in a daisy chain. All slave devices will then work synchronously with the master device.
Configure all slave units before connecting the master unit to the daisy chain. The
maximum number of slave units you can connect to a master unit is 18.
Slave Units
Connect the DMX input from your slave device to the DMX output of the previous device
in the chain. Connect the slave device to the mains to switch it on. Repeat these steps
for all slave units.
Master Unit
Connect the master device to the mains to switch it on. Press MENU to enter the menu.
Set the master unit to work in one of the running modes. Connect the master unit as
the first unit in the chain by connecting the DMX output of the master device to the
DMX input of the first slave unit.
V. 03 – 18/07/2018
HQLE10036
programme
Au1-Au7
auto programme
So1-So7
sound programme
SP1-SP9
adjustable speed value
Se1-Se9
adjustable microphone value
OFF
open on music by sound programme
ON
closed on music by sound programme
ON
enable IR remote reception
OFF
disable IR remote reception
4CH
4-channel DMX mode
13CH
13-channel DMX mode
slav
slave mode
dISP
normal display
dSiP
inversed display
10
description
d001-d512
d001-d512
©Velleman nv
Advertenties
Inhoudsopgave
