Complete Operating Manual And Warranty Conditions - Kostal PLENTICORE BI Handleiding

Inhoudsopgave

Advertenties

Beschikbare talen

Short manual

IMPORTANT INFORMATION

The battery inverter may only be installed, maintained and repaired by a trained and qualified

electrician. The electrician is responsible for ensuring that the applicable standards and

regulations are observed and implemented. Work that could affect the electrical power

system of the relevant energy supply company at the site of the solar power feed-in, may

only be carried out by qualified electricians expressly authorised (licensed) by the energy

supply company. This includes changes to the factory default parameters in the battery

inverter, which can be changed using the Webserver.

It must be ensured that the L1-L3 phases on the battery inverter's AC terminal and the

phases in the grid are assigned uniformly.

If residual current protection equipment (RCD) is used, a type A RCD ≥300 mA can be used

on the AC side. Use of a type A RCD is set in the Webserver. (Default setting: compatibility

with type A RCD).

POSSIBLE DAMAGE

Potential risk of damage when putting down the battery inverter. Always place the battery

inverter on its back after unpacking.

If the DC input is incorrectly wired, the battery inverter may be damaged. Check the

maximum wiring values before commissioning.

Installation

Perform battery inverter assembly, installation and commissioning based on the information

provided in the Installation chapter on page 56 onwards