Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
EN
Pack Contents
The following is included:
•
POLAR Refrigerator/Freezer
•
Shelves
CZ781 x 10
CZ782 x 10
CZ783 x 10
CZ784 x 10
•
Keys x 2
•
Instruction Manual
POLAR prides itself on quality and service, ensuring
that at the time of unpacking the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit,
please contact your POLAR dealer immediately.
Installation
Note: Not for use in vans or trailers, food
trucks or similar vehicles.
If the unit has not been stored or moved in
an upright position, let it stand upright for
approximately 12 hours before operation.
If in doubt allow to stand.
1. Remove the appliance from the packaging.
Make sure that all protective plastic film and
coatings are thoroughly removed from all
surfaces.
2. To optimize performance and longevity, ensure
a minimum clearance of 2.5cm is maintained
between the unit and walls and other objects,
with a minimum 20cm clearance on the top.
NEVER LOCATE NEXT TO A HEAT SOURCE.
Note: Before using the appliance for the
first time, clean the shelves and interior
with soapy water then dry well.
4
CZ781_CZ782_CZ783_CZ784_ML_A5_v1_20240506.indb 4
CZ781_CZ782_CZ783_CZ784_ML_A5_v1_20240506.indb 4
Operation
Control Panel
The control panel is located on the front of the
appliance.
Turn On
1. Close the door of the appliance.
2. Connect the appliance to a mains power
supply.
Set the Operating Temperature
1. Press the SET button for 3 seconds. The
display will flash.
2. Press the
or
required temperature.
3. Press the SET button to store the temperature.
Manual Defrost
Press and hold the defrost button "aux" for 2
seconds to begin a manual defrost. The defrost
light illuminates.
The defrost cycle will end automatically.
Condensation and ice will form with frequent
and prolonged opening of the doors.
Operating outside of the recommend
temperature range and placing next to a
heat source will also increase the amount
of ice and internal/external condensation.
If external condensation occurs wipe the
surface down with a cloth.
Excessive ice will result in longer running
times that will increase energy consumption
and increase the deterioration of
components.
Do not obstruct fans and do not exceed
max load lines, as doing so will impact air
distribution and increase energy usage.
buttons to display the
2024/5/6 13:41
2024/5/6 13:41
Advertenties
Inhoudsopgave
