Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
EN
Vacuum Sealer Use instructions
This appliance is for household use only.
To protect against electric shock, do not immerse cord, plug or any
parts of the appliance into water or other fluids.
Do not use the appliance near explosives, highly flammable mate-
rials, gases or burning flames.
Do not allow children, disabled people or every pe-
ople without experience or technical ability to use
the appliance if they are not properly watched over.
Close supervision is necessary when any appliance
used by or near children.
General safety advice
The vacuum sealer is for indoor use only. Do not use the product outdoor.
Be sure that the product is dry before any use. Unplug the device
when not in use.
Do not touch the heat sealing strip during or immediately after use.
Product description Fig.A
1. Vacuum sealing button
2. Sealing button
3. External vacuum tube port
4. Air release valve
5. Unlock buttons
6. Stop line
7. Heat sealing strip
8. Vacuum chamber
9. External vacuum tube
Instruction for use
Vacuum and sealing
Put the bag with the open side inside the vacuum chamber (Fig. B). Close the lid, you should hear a click on each
side of the product. Press twice consecutively the vacuum sealing button (VAC SEAL) (Fig. C), a blue LED turns
on and the vacuum starts. When the blue LED turns off, it means that vacuum and sealing are finished, so lightly
pull the air release valve and push the unlock buttons to set free the bag (Fig. D).
To seal a bag without vacuum, put the bag inside the vacuum chamber, close the lid until you hear two clicks and
press twice consecutively the sealing button (SEAL). A blue LED turns on and after a few seconds some air is
vacuumed in order to let seal the bag. When the blue LED turns off sealing is over, so lightly pull the air release
valve and push the unlock buttons. To stop vacuum and sealing functions, press for once vacuum sealing or
sealing buttons in any time. The bag width must not exceed 30 cm otherwise it cannot be welded correctly. Use
only nylon-PE films with a structure (points or grooves) on one side and a thickness of approximately 0.15-0.30
mm. Otherwise the weld seam will not be tight and the appliance may be damaged. The quality of the weld seam
will vary depending on the type and thickness of the bag. To make external vacuum, connect the tube to the
canister (not included) and to closed vacuum sealer machine by the external vacuum tube port (Fig. E). Press
twice consecutively the vacuum sealing button (VAC SEAL) (Fig. F). A blue LED turns on and the vacuum starts.
When the blue LED turns off the vacuum process is over.
Unplug the cable after each use and do not close the lid, leave it slightly raised without hearing closing clicks.
7
Advertenties
Inhoudsopgave
