Download Inhoudsopgave Inhoud Print deze pagina

Cabinet Requirements; Electrical Connection - Faber GALILEO BK GLASS NG A830 Gebruikshandleiding

Inhoudsopgave

Advertenties

Beschikbare talen
  • NL

Beschikbare talen

  • DUTCH, pagina 86
itself both for the regeneration method and for the
replacement times.
• Grease filters Z: The filters must be cleaned every
2 months of operation, or more frequently for
particularly heavy usage, and can be washed in a
dishwasher. Do not wash the grid in the dishwasher.
General recommendations
• Never use scouring pads, steel wool, muriatic
acid or other products which could scratch or
mark the surface.
• Foods that accidentally fall or settle on the surface,
on the functional or aesthetic elements of the hob
must not be eaten.
Cleaning the appliance
• Clean the appliance after every use in order to
prevent food residues from burning on. Cleaning
dried-on and burnt-on dirt requires more effort.
• To clean everyday dirt, use a soft cloth or sponge
with water and a suitable cleaning agent. Follow
the manufacturer's advice with regard to cleaning
agents. We recommend using protective cleaning
agents.
• Remove encrusted dirt, e.g. from milk that has
boiled over, with a glass ceramic hob scraper
while the hob is still warm. Please follow the
manufacturer's advice with regard to the scraper.
• Remove sugary foods, such as marmalade, that
have boiled over with a glass ceramic hob scraper
while the hob is still warm. Otherwise, this could
damage the glass ceramic surface.
• Remove melted plastic with a glass ceramic hob
scraper while the hob is still warm. Otherwise, this
could damage the glass ceramic surface.
• Remove limescale stains using a small amount
of lime-dissolving solution, e.g. vinegar or lemon
juice, when the hob has cooled down. Then clean
again with a damp cloth.

4. CABINET REQUIREMENTS

• The cooking hob is intended to be built into the
worktop above a kitchen cabinet of 600 mm
width or more.
• If fitting in flammable material, the guidelines and
standards for low voltage installations and for the
fire protection must be strictly observed.
• For fitted units, the components (plastic materials
and veneered wood) must be assembled with
heat-resistant adhesives (min. 100 °C): Unsuitable
materials and adhesives can result in warping
and detachment.
• The kitchen cabinet must allow sufficient room
6
for the electrical connections of the appliance.
Suspended kitchen cabinets above the appliance
must be installed at a distance that provides enough
room for comfortable working process.
• The use of hard wood decorative borders around
the worktop behind the appliance is allowed, in this
case the minimum distance remains as indicated
on the installation illustrations.
• The minimum distance between the fitted device
and the rear wall is indicated in the installation
drawing for the flush-fitted device (150 mm for
the side wall, 40 mm for the rear wall and 500
mm for any wall-mounted units above it. For
ergonomic reasons a minimum distance of 1000
mm is recommended).
• To prevent leakage of liquid between the edge of
the hob and the countertop, place the adhesive
seal provided along the entire outer edge of the
hob before assembly.

5. ELECTRICAL CONNECTION

• The wire connection has to be done by specialized
technician.
• This appliance has a Type "Y" attachment and re-
quires at least a power supply cord Type H05VV-F.
MONO-PHASE, BI-PHASE and THREE-PHASE
connection: min. section of the conductors: 2,5
mm². External diameter of the supply cord: min.
7 mm - max. 15 mm.
• Connection terminals are revealed when the
connection box cover is removed.
• Make sure the characteristics of the household
electrical system (voltage, maximum power and
current) are compatible with those of the appliance.
• Connect the appliance like shown in the diagram
(in accordance with the mains voltage and country
standard reference).
• We suggest to use power supply cord
5 x 2.5 mm² H05V2V2-F. In case of use of pow-
er supply cord 5 x 2,5 mm² H05V2V2-F, below
instructions have to be followed: for three-phase
connection separate the 2 wires and remove the
blue sheaths on grey wires.
6. DISPOSAL
• The symbol
on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it shall be handed over
to the applicable collection point for the recycling
of electrical and electronic equipment. By ensuring
this product is disposed of correctly, you will help
prevent potential negative consequences for the
environment and human health, which could oth-
erwise be caused by inappropriate waste handling
of this product. For more detailed information about
recycling of this product, please contact your local
city office, your household waste disposal service
or the shop where you purchased the product.
• The appliance is in accordance with the Directive
2012/19/EU, regarding the reduction of the hazard-
ous substances used in electrical and electronic
appliances, and waste disposal.

Advertenties

Inhoudsopgave
loading

Inhoudsopgave