Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
•
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and
the dealer will not accept responsibility for any ensuing defects or problems.
•
Keep this manual for future reference.
4.
Features
•
11 m black cable with IP44 power plug
•
with 20 pcs of E27 lamps:
HQPL11010: 4 pcs each colour (red, yellow, green, blue, white)
o
HQPL11011: 20 pcs warm white.
o
5.
Installation
For outdoor use, do not install the chain or replace lamps during rain or other inclement
weather conditions.
Inspecting the Chain Before Installation
1.
Take the chain out of the box and unroll it fully.
2.
Make sure that the power plug is disconnected from the power supply.
3.
Check the plug, cable, insulation, lamp holders, and lamps for damage:
Replace any damaged lamps. See Fitting or Replacing Lamps for detailed instructions.
o
If you notice any other damage, do not use the chain and contact your dealer.
o
4.
Make sure that the lamp holders are dry and clean on the inside and outside.
5.
Check if the electrical connectors in the lamp holders are in the correct position. One shall be flat at
the bottom of the socket, the other shall point upwards, as shown in the image. If you find a socket
with both connectors pointing upwards, bend one down to match the other sockets.
Caution: only do this when the power is disconnected.
Fitting or Replacing Lamps
1.
Make sure that the power plug is disconnected from the power supply. Do not replace lamps during
rain or other inclement weather conditions.
2.
To replace a lamp, carefully unscrew the faulty lamp.
3.
Fold down the rubber gasket over the lamp holder. This makes it easy to fit the lamp.
4.
With the gasket folded down, screw the lamp into the lamp holder.
V. 02 – 04/08/2021
HQPL11010 - HQPL11011
OK
3
Not OK
©Velleman nv
Advertenties
Inhoudsopgave
