Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
2.
Safety note
The instrument is built and tested in accordance with
DIN VDE 0404 part 1 and 2
DIN VDE 0411 part 1/ EN 61010 part 1
DIN VDE 0413 part 1/ EN 61557 part 1, 2, 4 and 10
and has left the factory in perfectly safe technical state.
To maintain this state and ensure safe operation of the appliance tester, the user must observe
the notes and warnings given in these instructions at all times. Improper handling and non-
observance of the warnings might involve severe injuries or danger to life.
WARNING! Be careful when working with bare conductors or main line carrier!
Contact with live conductors will cause an electric shock!
The BENNING ST 710 may be used only in power circuits within the overvoltage
category II with a conductor for 300 V AC max. to earth.
Remember that work on electrical components of all kinds is dangerous. Even
low voltages of 30 V AC and 60 V DC may be dangerous to human life.
Before starting the appliance tester up, always check it for signs of damage.
Should it appear that safe operation of the appliance tester is no longer possible, it should be
shut down immediately and secured to prevent it being switched on accidentally.
It may be assumed that safe operation is no longer possible:
-
if the instrument show visible signs of damage
-
if the appliance tester no longer functions
-
after long periods of storage under unfavourable conditions
-
after being subjected to rough transport
-
the device is exposed to moisture.
In order to prevent danger
-
do not touch the bare measuring probe tips of the measuring lines,
-
plug the lines into the correspondingly marked jacks at the measuring
instrument
Maintenance:
Do not open the tester, because it contains no components which can be
repaired by the user. Repair and service must be carried out by qualified
personnel only!
Cleaning:
Regularly wipe the housing by means of a dry cloth and cleaning agent. Do not
use any polishing agents or solvents!
3.
Scope of delivery
The scope of delivery for the BENNING ST 710 comprises:
3.1 One BENNING ST 710,
3.2 One test cable with alligator clip,
3.3 One IEC power cord (IEC adapter cable)
3.4 One compact protective pouch,
3.5 Six 1.5-V-batteries/ type AA (IEC LR6) fitted in the unit as original equipment,
3.4 One operating instructions manual
Parts subject to wear:
-
The BENNING ST 710 is supplied by six 1.5 V batteries/ type AA (IEC LR6).
Note on optional accessories:
-
Leakage current clamp BENNING CM 9 for differential current measurement of single-phase
and three-phase loads (044065)
-
Test badges "next test date", 300 pieces (756213)
-
Measuring adapter shock-proof plug/ shock-proof coupling for measuring the differential
current, protective conductor current and load current of single-phase loads, conductors led
through individually (044131)
-
Measuring adapter for three-phase loads
for measurement of RPE and RISO:
-
16 A CEE coupling - shock-proof plug (044122)
-
32 A CEE coupling - shock-proof plug (044123)
for measurement of differential current, protective conductor current and load current:
-
16 A CEE coupling - CEE plug (044127)
01/ 2009
BENNING ST 710
12
Advertenties
Hoofdstukken
Inhoudsopgave
