Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
EN
4. Aiming the laser onto the target and quickly
pressing the measure button (2) again for
measuring the width.
5. Pressing the measure button (2) will activate
the laser.
6. Aiming the laser onto the target and quickly
pressing the measure button (2) again for
measuring the second width. The calculated re-
sult is shown in the main line and the measured
value above.
Single pythagorean measurement
Press the function button (3) to change measure-
ment function to single pythagorean measurement.
Select the function and begin the measurement.
1. Pressing the measure button (2) will activate
the laser.
2. Aiming the laser onto the target and quickly
pressing the measure button (2) again for
measuring the upper point. The result is dis-
played immediately.
3. Pressing the measure button (2) will activate
the laser.
4. Aiming the laser rectangular onto the target and
quickly pressing the measure button (2) again
for measuring the lower point. The calculated
result is shown in the main line and the measu-
red value above.
Addition(+) and subtraction (-) function (Fig. A+J)
1. When the device is switched on, quickly press
the measure button (2) to activate the laser
(10).
2. Aiming the laser onto the target and quickly
press the measure button (2) again will trigger
single-mode measurement; the result is dis-
played immediately.
3. Quickly press the addition (5) or subtraction (6)
button.
4. Quickly press the measure button (2) to activate
the laser (10).
5. Aiming the laser onto the target and quickly
press the measure button (2) again will trigger
single-mode measurement. The calculated re-
sult is shown in the main line and the measured
value above.
This process can be repeated as required. The
same process can be used for adding (+) or
subtracting (-) areas or volumes.
8
Display Notices
The following errors can be corrected.
Message
Cause
Code
Background brightness
Err08
too high
Err10
Battery too low
Err15
Out of range
Err16
Received signal too weak
(Fig. A+I)
5. MAINTENANCE
Cleaning
NOTICE! Risk of product damage! Never
submerge device in water while cleaning.
Do not use cleaning agents or solvents.
Wipe the device using a dry cloth.
Storage
NOTICE! Risk of product damage! Always
handle measuring instruments with care.
• Store the product in a dry, well-ventilated place.
• Only store and transport the product in its origi-
nal packaging.
• Prevent large temperature fluctuations: Always
temper the product for a while before use in
extremely cold or hot environments.
Taking out of operation for a longer period of time
• When not in use for a longer period of time,
remove the batteries.
NOTICE! Risk of product damage!
Old, leaky batteries can damage the
product. Check the battery regularly.
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/EC
for Waste Electrical and Electronic Equipment and its
Remedy
Use dark colored target
Change batteries
Measure target within the
range
Use light colored target;
Hold Quick Measure more
steadily
WWW.VONROC.COM
Advertenties
Inhoudsopgave
