Inhoudsopgave
Advertenties
ADVAntAGeS
Connect310
• Connecting 3 HDMI sources with one cable
• Supports up to 1080P HDTV resolution
• HDMI V1.3 certified by ATC (Authorized Test Centers)
• Meets the HDCP standards (High-bandwidth Digital Content Protection)
• C an be placed out of sight and can still be operated with the remote control when using
the external infrared receiver.
HDMI V1.3
• V ideo bandwidth 225 MHz (makes image reproduction of 1080P, 12-bit and 60Hz
possible)
• D eep Color 12-bit (billions instead of millions colours, better reproduction of subtle
differences in gradation and a higher contrast ratio)
• Dolby TrueHD & DTS HD Master Audio (high quality audio support)
• Lip-Sync (prevents synchronisation problems between image and sound)
• CEC (operate multiple 'CEC' devices with just one remote control).
InStALLAtIon
1. C onnect the HDMI cable to your screen (TV, monitor of projector) with the "HDMI
output" of the Connect310.
2. Connect the HDMI cables from your sources to the "HDMI inputs" of the Connect310.
3. C onnect the external infrared receiver to the "IR Extender" input of the Connect310 and
mount it somewhere in sight of your remote control. For example up, under or at the side
of your A/V centre. This way you can keep operating the Connect310, even when it is
located in a closed cabinet.
4. C onnect the power adaptor to the power connector of the Connect310 and connect to
the mains.
Remark 1:
In most cases the Connect310 operates without power adaptor. Standard all HDMI cables
are equipped with a 5V power pin, but unfortunately not all HDMI sources support this
functionality. So it depends on your HDMI sources if connecting the power adaptor to the
Connect310 is necessary. You can test this by simply disconnecting the power adaptor from
the Connect310 and see if it is still functioning properly.
Remark 2:
Use only category 2 HDMI certified cables for the best quality in image and sound.
© MARMITEK
Advertenties
Inhoudsopgave
