Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
6.0
STAND-ALONE INSTALLATION
The doorbell can also function outside an existing installation. Through the Alecto service department
you may order an extra separate wireless doorbell (DVC-25). The additional separate wireless doorbell
is inserted directly into a wall socket.
6.1
TO CONNECT THE DOORBELL PUSHER
The doorbell pusher should be connected to an external adaptor or doorbell transformer. The adaptor
must supply a minimum of 1 Amp while the voltage must 12 V. This may be either direct current or
alternating current.
Connect the doorbell pusher in the same way as is described in the paragraph 4.0 Installation.
The wires found at the old doorbell now serve for the adaptor or transformer. See below diagram:
adaptor
transformer
You may also place the transistor close to the adaptor or transformer.
6.2
TO CONNECT THE (EXTRA) DOORBELL
You may order a wireless doorbell via the service department of Alecto. This doorbell is also suitable
as an additional doorbell for an existing installation. When you've received the doorbell, it should be
inserted into a free wall socket.
Use the doorbell melody setting to select the desired melody (36 melodies).
Press the Setting button
Use the doorbell volume setting
To do so, repeatedly press the
To register the doorbell on the DVC-1000 doorbell pusher
1.
press the
2.
press the button of the DVC-1000 doorbell once and then release the
button of the extra doorbell
3.
the wireless doorbell is now registered on the DVC-1000
or
12V~
12VDC
for the next melody.
to adjust the volume in 3 increments.
button.
button and keep it depressed
- 51 -
Resistor
Advertenties
Inhoudsopgave
