5. Description Receiver
1. power switch
2. antenna socket
3. power socket
4. A/V output
5. antenna
6. channel button
7. channel indicator
6. Installation
1.
Put the camera in the desired location and then adjust the angle.
2.
Connect the adapter (DC 8V 200mA) to the camera.
3.
Connect the antenna to the receiver.
4.
Connect the adapter (DC 8V 200mA) to the receiver. Slide the power switch to the ON position.
5.
Connect the receiver to a monitor/TV with the A/V cable (yellow for video and red for audio).
6.
Switch on the monitor/TV and select A/V mode.
7. Use the channel button to
displayed on the monitor/TV.
8.
Adjust the brightness, contrast and colour of the monitor/TV.
7. Camera Channel Set-up
Remove the camera cover and reach for the DIP switches next to the lens. Choose a channel by setting the DIP
switches. Replace the camera cover. Use the SEL button to select the same channel for the receiver as for the
camera. The image is now displayed on the TV.
8. General Guidelines
• Protect the device against water and don't put objects containing water (e.g. vases) on top of the device
Turn off the camera/receiver if the system is not in use.
•
Use the adapter to connect /disconnect the device with/from the mains.
•
Do not cut off the DC power cable to try and use it with a different power source
•
9. Specifications
Operating temperature
Storage temperature
Operating humidity
Camera (order code SCAMW2, also compatible with SCAMW3, SCAMW4)
Imaging sensor
Total pixels
Viewing angle
Transmission frequency
Transmission power
Modulation type
Bandwidth
Power supply
Current Consumption
Effective range (line of sight)
Dimensions (W x D x H)
Weight
SCAMSETW2
set the same channel on the receiver as on the camera .The camera picture is now
0 to +50°C/ +32 to +122°F
-30
to +80°C/ -22 to +176°F
85% RH
CMOS
628 x 582 (PAL); 510 x 492 (NTSC)
62°
2.400 to 2.483MHz
10mW/CE; 2mW/FCC
FM
18MHz
8V DC
80mA & 120mA (IR ON)
100m
Ø 44 x 56mm (without bracket)
220g
4
PEREL