Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
20
You can operate the device with the control panel or the remote supplied with the unit. The
remote control has the same functions as the control panel on top of the device.
Prior to use, install the battery according to the following instructions:
1. Slide out the battery tray.
2. Insert CR2025 battery with correct polarization.
3. Slide the tray in so that it locks in place.
After operating for long time, the dust accumulated in the dust filter or paper filter may
influence the airflow. Therefore it is recommended to clean device and filters regularly. Please
follow the steps below to clean your device.
Turn off the unit and unplug the power cord before cleaning and maintenance.
• Do not use any abrasives or chemical agents to clean any parts of the device.
• Make sure all the parts of the device are dry before use.
Dust filter
Remove the screw, then press both locks simultaneously and pull out the dust filter. Use a
EN
brush to clean the dust and dirt from the filter. If necessary clean it gently with a slightly
damp cloth. Make sure to wipe it dry before refitting. Reassemble the filter so that it locks in
place.
Paper filter
After removing the dust filter you can see the paper filter. Take it out of the device. Use a
clean, soft brush to remove dust and dirt. Rinse with water if needed and leave it to dry in
open air.
Water tank
Turn the water tank lock to horizontal position and pull the water tank. Use soft cleaning
agents for cleaning. Wash with water and rinse then place it to its housing by pushing gently.
Turn the lock to vertical position.
Housing
Clean the housing with a soft, slightly damp cloth.
REMOTE CONTROL
CLEANING AND MAINTENANCE
Owner's manual
Advertenties
Inhoudsopgave
