Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Connection
For the connection of the inputs only use the shielded cinch wires. Use of any other cables may
cause interferences.
To avoid distortions or mismatches that may damage the amplifier, the cinch inputs must only
be connected to sources with a cinch output.
Connection to the speakers must be two-wire each. Insulate any open connection points. Make
sure that the cables are not damaged by sharp edges.
Only use speakers with sufficient load capacity (see "Technical Data").
Connect the speakers directly to the power amplifier. Do not use any headphones or junction
boxes! If in doubt, contact a specialist.
Observe that the speakers have the correct polarity - that is, that plus and minus marks match.
This amplifier has been designed for a speaker impedance of at least 4 Ohm on each channel.
Never connect speakers with a lower impedance.
Also observe the connection values in the chapter "Technical Data".
a) Connection of the In- and Outputs
•
Connect the outputs of your audio source (mixer, equalizer, etc.) to the inputs of the amplifier.
Connect the left channel to the input socket LINE IN CH1 (3). Connect the right channel to the input
socket LINE IN CH2 (3).
•
Connect the left speaker to the speaker output POWER OUT CH1 (4). Connect the right speaker to the speaker
output POWER OUT CH2 (4).
Connect the plus pole of the speaker to the red speaker output terminal and the minus pole of the
speaker to the black speaker output terminal.
23
Advertenties
Hoofdstukken
Inhoudsopgave
