Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
1. Introduction & Features
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialised
company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying the SSE025! If the device was damaged in transit, don't install or use it and contact your dealer.
Features:
• Electronic lock: easy to operate and programmable with 3 to 8 digits
• Manual override key system
• LEDs for security and power status
• Buzzer feedback for each operation
2. General Guidelines
• Familiarise yourself with the functions of the device before actually using it. Any damage that may occur will most
probably be due to unprofessional use of the device.
• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
crash, etc. Using the device in an unauthorised way will void the warranty.
3. Opening the Safe
• Press 1, 5 and 9 consecutively. These are the factory preset numbers.
• Confirm by pressing the START button. You will hear a beep and the green indicator will light up.
• Open the door using the knob within 5 seconds.
The door will not open when entering the incorrect numbers. When you enter an incorrect combination 3 times
consecutively wait for 20 seconds before reattempting.
If an incorrect combination is entered 3 times again, wait approximately 5 minutes before reattempting.
CAUTION: Do not keep your override keys in the safe.
4. Programming the Code
• Press the red button on the back of the door near the hinge. Release it and you will hear two beeps and see the
yellow indicator light up.
• Enter the desired code from 3 to 8 numbers and confirm by pressing the START button within 15 seconds.
• Write down the code and check if it has been programmed correctly.
SSE025
SSE025 – ELECTRONIC SAFE
- 3 -
PEREL
Advertenties
Inhoudsopgave
