Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
All manuals and user guides at all-guides.com
P73055/F1D108-OSD/EU/man.qxd
SCAN TIME:
Amount of time the OmniView
on one port before switching to the next
port when in Scan Mode.
DISPLAY TIME:
Amount of time the OSD Menu or Port
Name remains displayed on-screen after
making a port selection.
NOTE: If there are slave units present, the SCAN TIME and DISPLAY TIME settings are set on
the MASTER unit only, and need not be set on the slave units.
The BANK/SCAN Button:
Pressing the BANK/SCAN button cycles you through all the active BANKS (if there are slave
units present) and then puts the unit in AutoScan mode. If the unit is a single MASTER unit,
pressing the button immediately invokes AutoScan mode. This is evident by a long BEEP,
followed by two short beeps.
4/21/00
2:25 PM
Page 14
Usage
(continued)
SCAN TIME:
PRO stays
™
7sec
DISPLAY TIME:
7sec
[ ]: SELECT
(INS): RENAME
(Enter): COMPLETE
(Esc):
Exit
14
15sec
30sec
60sec
15sec
30sec
60sec
Advertenties
Inhoudsopgave
