Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Put the plug of the appliance into the power socket.
Choose the desired temperature.
Turn the variable steam dial between
steam.
Set the iron on its heel and wait until the temperature indicator goes out.
Caution: Set the temperature dial within the steam range ('
setting is too low, water may drip from the soleplate.
Check the garment label before ironing because some clothes may be damaged when
exposed to steam or water.
BURST OF STEAM
The burst of steam feature
This button also allows you to iron delicate articles of clothing vertically. This feature is called
"vertical burst of steam". To do so, hang your article of clothing on a hanger, keep the steam
button pressed and pass the iron to and fro in front of the article of clothing, making sure that
the soleplate does not come into contact with the article of clothing. The distance between
the soleplate and the article of clothing depends on the kind of textile and the creases.
AUTOMATIC CUTOUT
The automatic cut-off device trips after the iron has been left for approximately eight minutes
in the upright position or unused for approximately thirty seconds in the horizontal position. The
temperature indicator will flash & some beeps are issued to indicate that the cut-off device
has tripped. As soon as you move the iron, the device turns off and the iron starts working
again.
ANTI-CALC FEATURE
There is a decalcification box inside the appliance, which can absorb unsolvable calcium ion
and send out solvable sodium ion so that water can be softened, and the process of calcium
depositing would be much slower.
CARE AND CLEANING
Clean the iron regularly according to the hardness of the water and the frequency of use.
Fill the water tank and put the thermostat in MAX position.
Plug in the appliance. The pilot light will come on. Make sure the steam dial is in
position.
Never use vinegar or other liquids to descale the iron.
As soon as the pilot light goes out, hold the iron over a sink and press the steam button
again and again. Steam, water and dust particles will come out of the soleplate.
When the water tank is empty, release the steam button.
To clean the plastic parts of the iron, use a humid cloth.
To clean the soleplate, make sure you use a product made especially for this purpose.
Never use abrasive products.
WHEN YOU HAVE FINISHED IRONING
Turn the temperature dial to "MIN/OFF" and the steam dial to
the electrical outlet.
and
provides additional steam for removing stubborn creases.
17
according to the desired amount of
' or '
'). If the temperature
and unplug the iron from
Advertenties
Inhoudsopgave
