Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
GB
FR
DE
ES
33. Grooved gripping section
34. Live tool indicator
35. Collet sleeve
36. Tool head
SPECIFICATIONS
Input
Rated speed
Collet
Weight
OPERATION
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is
suffi cient to infl ict serious injury.
Always wear eye protection. Failure to do so could
result in objects being thrown into your eyes, resulting
in possible serious injury.
Do not use any attachments or accessories not
recommended by the manufacturer of the product. The
use of attachments or accessories not recommended
can result in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:
Cutting
Sanding
Polishing and buffing
Engraving
Drilling
Grinding
TURNING THE ROTARY TOOL ON/OFF
See Figure 2.
To turn the tool on: Slide the switch to "|".
To turn the tool off: Slide the switch to "O".
IT
NL
PT
DK
SE
230 V - 240 V
50 Hz
10,000-35,000 (RPM) min
3.2 mm max.
0.73 kg
WARNING
WARNING
WARNING
FI
NO
RU
PL
CZ
English
To prevent damage to the spindle or spindle lock,
always allow motor to come to a complete stop before
engaging the spindle lock.
CHANGING COLLETS
See Figure 3.
-1
Unplug the tool.
Press and hold the spindle lock, and rotate the shaft
with the provided collet wrench until the spindle lock
engages the shaft, preventing further rotation.
With the spindle lock engaged, use the collet wrench
to loosen the collet nut, if necessary.
Remove the collet nut and old collet using collet
wrench, if necessary.
Insert the unslotted end of the collet in the hole in the
end of the tool shaft.
Replace the collet nut on the shaft.
Always use the collet which matches the shank size
of the accessory you plan to use. Never force a large
diameter shank into a collet. The accessory should
fi t smoothly into the collet, but you should be able to
tighten the accessory fi rmly and securely with the
provided wrench.
If you are changing an accessory immediately after
use, be careful not to touch the collet, collet nut, or
the accessory with your hands or fi ngers. You will
get burned because of the heat build-up from cutting.
Always use the wrench provided.
INSTALLING ACCESSORIES
See Figure 4–5.
Unplug the tool.
Press and hold the spindle lock, and rotate the shaft
by hand until the spindle lock engages the shaft,
preventing further rotation.
With the spindle lock engaged, use the collet wrench
to loosen the collet nut, if necessary.
Insert the shank of the accessory into the collet until
the shank bottoms out, then pull it out 1.6 mm (1/16 in)
to allow for expansion when the accessory gets hot.
With the spindle lock engaged, tighten the collet nut
4
HU
RO
LV
LT
EE
CAUTION
WARNING
DANGER
HR
SI
SK
GR
TR
Advertenties
Inhoudsopgave
