Download Inhoudsopgave Inhoud Print deze pagina

Tips On Saving Energy; Caring For Your Appliance - Indesit RGA 250 Handleiding

Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

Tips on Saving Energy

- Install the Appliance Properly
In other words, away from sources of heat and direct sun-
light, in a well ventilated room complying with the minimum
distances indicated in the paragraph entitled, " Installation/
Ventilation."
- Use the Right Temperature Setting
A setting which is too cold increases energy consumption.
- Do not Overfill
To conserve food properly, the cold air must circulate freely
within the refrigerator. If it is overfilled, this will prevent proper
air circulation, forcing the compressor to work continuously.
- Close the Doors
Open your refrigerator as little as possible because each time
you do so you loose much of the cold air. To raise the tem-
perature to the proper level again, the motor must work for
a long time, consuming energy.

Caring for Your Appliance

Defrosting
Do not use mechanical devices or other tools to speed
up the defrosting process, unless they have been rec-
ommended by the manufacturer.
How to Defrost the Refrigerator
This appliance defrosts automatically and the water is channeled to
the back toward the drain installed for this purpose (fig. 3). Here, the
heat produced by the compressor will make it evaporate. The only
thing you must do is to periodically check and clean the hole of the
drain, which is located behind the vegetable crispers, so that the wa-
ter drains properly.
How to Defrost the Freezer
- Every so often, remove the frost with the scraper provided
with the appliance (do not use knives or metal objects).
- If the frost is more than 15 mm thick, the freezer must be
defrosted.
Proceed as follows: turn the thermostat knob (A) to the ·
setting
. Then wrap all the frozen and fast-frozen food in
newspaper, placing it either in the refrigerator or in a cool
place. Leave the freezer door open so that the frost thaws
completely. You can speed this process by placing containers
of warm water in the compartment.
Cleaning and Special Maintenance
Before cleaning the refrigerator, remove the plug from
the socket.
- The materials used to build your appliance are hygienic
and do not transmit odors. However, to preserve this quality
of your appliance, the food stored in it must be well closed
and covered to prevent spills which could stain it and cause
unpleasant odors.
All manuals and user guides at all-guides.com
- Keep an Eye on the Seals
Keep the seals clean and make sure that they adhere well to
the door. This alone will ensure that no cold air escapes.
- No Hot Foods
A hot pot or pan placed in the refrigerator immediately raises
the temperature several degrees. Let hot cookware and food
cool to ambient temperature before placing them in the re-
frigerator.
- Defrost the Freezer
Check the thickness of the frost on the walls of the freezer
and immediately defrost it if the layer of frost is too thick.
(see the section entitled, "Keeping your Appliance in Shape").
- Only water and baking soda. To clean both the interior and
exterior, use a sponge with warm water and baking soda,
which is, among other things, a good disinfectant. If you do
not have any in the house, you can use a neutral soap.
- What not to use. Never use abrasives, bleach or ammonia.
Solvents and similar products are strictly prohibited.
- All the removable part should be taken out and allowed to
soak in hot water and dishwashing soap. Rinse and dry them
well before putting them back in the refrigerator.
- And the back? This is where dust builds up, causing prob-
lems with the appliance. Use a long adapter on your vacuum,
at a medium power setting, to remove it. Be delicate!
- When the appliance is not used for a long time. If you
decide not to use the appliance (during the summer), it must
cleaned and the doors left open to prevent the formation of
mold and unpleasant odors.
- How to replace the refrigerator lamp. The lamp is located
on the pack part of the thermostat knob box. When replac-
ing the lamp, unplug the appliance from the electrical socket,
unscrew the burned out lamp and replace it with another
following the steps illustrated in figure 4. Make sure that
the wattage is not greater than 15W.

Advertenties

Inhoudsopgave
loading

Inhoudsopgave