Download Inhoudsopgave Inhoud Print deze pagina

Zanussi ZRA40100XA Gebruiksaanwijzing pagina 21

Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

Problem
Water flows on the rear plate of
the refrigerator.
Water flows inside the refrigera-
tor.
Water flows on the floor.
Door is misaligned or interferes
with ventilation grill.
The temperature in the appliance
is too low/too high.
If the advice does not lead to the
desired result, call the nearest
brand-mark service.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
www.zanussi.com
All manuals and user guides at all-guides.com
Possible cause
The water drainage plug is not
correctly positioned.
Food products are not wrap-
ped properly.
Temperature is set incorrectly.
During the automatic defrost-
ing process, frost melts on the
rear plate.
The water outlet is clogged.
Food products prevent that
water flows into the water col-
lector.
The melting water outlet is not
connected to the evaporative
tray above the compressor.
The appliance is not levelled.
The temperature regulator is
not set correctly.
The door is not closed correct-
ly.
The food products' tempera-
ture is too high.
Many food products are stored
at the same time.
The door has been opened of-
ten.
There is no cold air circulation
in the appliance.
Position the water drainage plug in
the correct way.
Wrap the food products better.
Refer to "Operation" chapter.
This is correct.
Clean the water outlet.
Make sure that food products do
not touch the rear plate.
Attach the melting water outlet to
the evaporative tray.
Refer to "Levelling".
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products temperature
decrease to room temperature be-
fore storage.
Store less food products at the
same time.
Open the door only if necessary.
Make sure that there is cold air cir-
culation in the appliance.
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
Replacing the lamp
1. Disconnect the appliance.
2. Push the movable part to unhook the lamp
cover (1).
3. Remove the lamp cover (2).
Solution
21

Advertenties

Inhoudsopgave
loading

Inhoudsopgave