Flange installation
Install the flange supplied to the upper or rear
exhaust outlet as desired (bayonet fastening).
1
2
Recirculation mode Only
This version of the hood is ready for installation.
Make sure the charcoal filter is installed and the
internal Extraction/Recirculation mode switch is
set to "Recirculation".
For further details relating to the charcoal filter,
please refer to the corresponding paragraph.
Wall unit mounting
• Make the holes on the bottom of the cupboard
• From inside the cupboard, insert the 4
Extraction mode
Recirculation
mode
(2), using the drilling template (1).
Make a hole for the exhaust pipe (4) if the
hood is to be used in the extraction mode (3).
supplied screws (5) and tighten them in the
appropriate holes on the appliance.
1
3
5
5
4
2
5
5
59